Submitted by Stev (not verified) on Fri, 04/11/2008 - 20:16.
Thanks JT. Those fuses are what I tried to set in PonyProg, but as soon as I write the disable div/8 it goes crazy. The support in PonyProg for ATTiny45/85 is in beta though, so that's probably why. I just didn't know of any other windows-based programmer that supported the DT-006 parallel interface.
Once the AVR Dragon comes in I'll use HV programming to reset the chips and try again with AVR Studio. I'm also going to see if Fry's has any 300? SMDs for once my new chips come in.
USA 
Canada 
Thanks JT. Those fuses are
Thanks JT. Those fuses are what I tried to set in PonyProg, but as soon as I write the disable div/8 it goes crazy. The support in PonyProg for ATTiny45/85 is in beta though, so that's probably why. I just didn't know of any other windows-based programmer that supported the DT-006 parallel interface.
Once the AVR Dragon comes in I'll use HV programming to reset the chips and try again with AVR Studio. I'm also going to see if Fry's has any 300? SMDs for once my new chips come in.