Submitted by Stev (not verified) on Mon, 04/07/2008 - 20:36.
I just completed my first Capslocker! Woo!
But whenever I plug it into a USB slot it says USB device not recognized, and that pops up about once every 5 seconds.
I've checked the Write operation, and it verifies correctly. I can also read the program back from the chip. The only thing I'm not sure about are the security bit settings. This is what I have on there right now.
CKDIV8, SUT0, CKSEL3, 2, 1, SPIEN
Are these correct? Any any ideas what could be causing it?
For reference, I'm using PonyProg with a DT-006 parallel port programmer.
USA 
Canada 
I just completed my first
I just completed my first Capslocker! Woo!
But whenever I plug it into a USB slot it says USB device not recognized, and that pops up about once every 5 seconds.
I've checked the Write operation, and it verifies correctly. I can also read the program back from the chip. The only thing I'm not sure about are the security bit settings. This is what I have on there right now.
CKDIV8, SUT0, CKSEL3, 2, 1, SPIEN
Are these correct? Any any ideas what could be causing it?
For reference, I'm using PonyProg with a DT-006 parallel port programmer.